Gestetner B070 Service Manual page 122

INSTALLATION OF MFP CONTROLLER OPTIONS
⇒
[B]
6. Connect the power repeater cable [A] to the mother board at CN149.
7. Connect the other end of the power repeater cable the connection PCB [B].
8. Insert the 64 MB SDRAM DIMM [C] into the slot on the mother board.
• Set the edge connector at a 45 degree angle with the slot on the edge
connector [D] aligned with the post below.
• Press down slightly then push the DIMM toward the mother board until it
snaps into place.
• Make sure that the notches on both sides of the DIMM [E] [F] engage the
pawls of the spring loaded arms so the DIMM is perpendicular.
9. Re-attach the controller box cover.
10. Repeat Steps 1 to 9 to install the connection PCB and 64 MB DIMM on the
slave machine.
B070/B071
CÓPIA NÃO CONTROLADA
[A]
1-88
CÓPIA NÃO CONTROLADA
Rev. 06/2003
[C]
[E]
[D]
[F]
T03040803.WMF
SM