Updating The Lcdc For The Operation Panel - Gestetner B147 Service Manual

FIRMWARE UPDATE

5.6.5 UPDATING THE LCDC FOR THE OPERATION PANEL

Follow this procedure to update the LCDC (LCD Control Board).
1. Turn the copier main switch off.
2. Insert the SD card into SD Card Slot 3.
3. Switch the copier main switch on.
4. After about 45 seconds the initial screen opens in English.
5. Touch "OpePanel".
6. Touch "UpDate(#) (or ) to start the update.
After about 9 seconds, the downloading starts.
While the data is downloading, the operation panel goes off and the main
power on key flashes in red at 0.5 s intervals. When the update is finished, the
same key starts flashing in green at 1 s intervals.
7. Switch the copier main power switch off, remove the SD card, then switch the
copier on again.
B147/B149/B190
PCcard -> ROM Page01
ROM: G0000000
Printer (1)
ROM: 0.01
ROM: B0705254
Engine (2)
ROM: 2.16:16
OpePanel.DOM (3) ROM: B0705370
ROM: 1.22
Verify(./*)
5-150
NEW: G0000000
NEW: 0.0X
NEW: B0705254
NEW: 2.16:16
NEW: B0705370
NEW: 2.00
Exit(0) UpDate(#)
B146S927.WMF
SM