Management Commands; Bridge Aging-Time; No Bridge Aging-Time - NETGEAR ProSafe GSM7224 User Manual

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software

Management Commands

These commands manage the switch and show current management settings.

bridge aging-time

This command configures the forwarding database address aging timeout in seconds. In an IVL
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Default
Format
Mode
Seconds
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding

no bridge aging-time

This command sets the forwarding database address aging timeout to 300 seconds. In an IVL
system, the [fdbid/all] parameter is required. In an SVL system, the [fdbid/all] parameter is not
used and will be ignored if entered.
Format
Mode
Forwarding Database ID Fdbid (Forwarding database ID) indicates which forwarding
Switching Commands
300
bridge aging-time <10-1,000,000> [fdbid | all]
Global Config
The <seconds> parameter must be within the range of 10 to
1,000,000 seconds.
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
no bridge aging-time [fdbid | all]
Global Config
database's aging timeout is being configured. All is used to con-
figure all forwarding database's agetime. In an SVL system, the
[fdbid/all] parameter is not used and will be ignored if entered.
202-10009-01_060204
8-17