Ipv6 Management Commands; Serviceport Ipv6 Enable; Network Ipv6 Enable - NETGEAR M6100 Series Reference Manual

IPv6 Management Commands

IPv6 Management commands allow a device to be managed via an IPv6 address in a switch
or IPv4 routing (i.e., independent from the IPv6 Routing package). For Routing/IPv6 builds of
NETGEAR Managed Switch software, dual IPv4/IPv6 operation over the service port is
enabled. NETGEAR Managed Switch software has capabilities such as:
• Static assignment of IPv6 addresses and gateways for the service/network ports.
• The ability to ping an IPv6 link-local address over the service/network port.
• Using IPv6 Management commands, you can send SNMP traps and queries via the
service/network port.
• The user can manage a device via the network port (in addition to a Routing Interface or
the Service port).

serviceport ipv6 enable

Use this command to enable IPv6 operation on the service port. By default, IPv6 operation is
enabled on the service port.
Default enabled
Format
serviceport ipv6 enable
Mode Privileged EXEC
no serviceport ipv6 enable
Use this command to disable IPv6 operation on the service port.
Format
no serviceport ipv6 enable
Mode Privileged EXEC

network ipv6 enable

Use this command to enable IPv6 operation on the network port. By default, IPv6 operation is
enabled on the network port.
Default enabled
Format
network ipv6 enable
Mode Privileged EXEC
M6100 Series Switches
IPv6 Commands
883