User Manual for the NETGEAR 7300 Series Layer 3 Managed Switch Software
config port linktrap
This command enables or disables link status traps by interface.
Note: This command is valid only when the Link Up/Down Flag is enabled. See "config trapflags
linkmode" on page 21 for more information.
Format
config port physicalmode
This command sets the speed and duplex setting for the interface.
Format
Acceptable values are:
100h
100f
10h
10f
config port lacpmode
This command enables or disables Link Aggregation Control Protocol (LACP) on a port. The
possible values for <mode> are enable and disable. The default value is disable.
Format
config port autoneg
This command enables or disables automatic negotiation on a port. The possible values for
<mode> are enable and disable. The default value is enable.
Format
show lag
This command displays an overview of all link aggregations (LAGs) on the switch.
Format
7-26
config port linktrap < slot.port|all>
<enable|disable>
config port physicalmode <slot.port|all>
<100h|100f|10h|10f>
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
100BASE-T full duplex
config port lacpmode <slot.port/all> <enable/disable>
config port autoneg <slot.port/all> <enable/disable>
show lag <logical slot.port|all>
202-10009-01
Switching Commands