T640 Core Router Hardware Guide
Related
Documentation
T640 Host Subsystem Overview
T640 Host Subsystem Description
Related
Documentation
32
Table 7: SIB LEDs
Label
Color
Green
ACTIVE
Green
OK
Yellow
FAIL
T640 Router Description on page 3
T640 Switch Interface Boards (SIBs) Description on page 30
Maintaining the T640 SIBs on page 193
Replacing a T640 SIB on page 280
T640 Host Subsystem Description on page 32
T640 Routing Engine Overview on page 33
T640 Control Boards Overview on page 42
The host subsystem provides the routing and system management functions of the
router. You can install one or two host subsystems on the router. To operate, each host
subsystem functions as a unit; the Routing Engine requires the corresponding control
board, and vice versa.
NOTE:
We recommend that you install two host subsystems for redundant
protection. If you install only one host subsystem, we recommend that you
install it in slot
RE0
Each host subsystem has three LEDs that display its status. The host subsystem LEDs
are located on the upper right of the craft interface. For more information about the host
subsystem LEDs, see
"T640 Craft Interface Host Subsystem LEDs" on page
T640 Hardware Component Overview on page 11
T640 Routing Engine Description on page 33
T640 Control Boards Description on page 43
Taking the T640 Host Subsystem Offline on page 256
Maintaining the T640 Host Subsystem on page 183
State
Description
On steadily
SIB is in active mode.
On steadily
SIB is functioning normally.
Blinking
SIB is starting up.
On steadily
SIB has failed.
.
54.
Copyright © 2013, Juniper Networks, Inc.