Reinstalling The T320 Sibs; Figure 54: Reinstalling A Control Board - Juniper Core Router T Series Hardware Manual
Hide thumbs
Also See for Core Router T Series:
- Monitoring and troubleshooting manual (812 pages) ,
- Handling instructions manual (12 pages)
Table of Contents
Advertisement
Reinstalling the T320 SIBs
Copyright © 2018, Juniper Networks, Inc.
Figure 54: Reinstalling a Control Board
To reinstall the SIBs (see
Figure 55 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the SIB.
5.
Tighten the captive screws on the ejector handles.
6.
Repeat the procedure for each of the remaining SIBs.
7.
Chapter 18: Installing the T320 Without a Mechanical Lift
146):
145
Advertisement
Table of Contents
Troubleshooting
