Reinstalling The T4000 Sibs; Figure 55: Reinstalling An Lcc-Cb - Juniper T4000 Hardware Manual

Reinstalling the T4000 SIBs

Copyright © 2018, Juniper Networks, Inc.

Figure 55: Reinstalling an LCC-CB

To reinstall the SIBs (see Figure 56 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Place one hand underneath the SIB to support it. With the other hand, hold one of the
2.
ejector handles on the SIB faceplate.
Carefully align the sides of the SIB with the guides inside the chassis.
3.
Slide the SIB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles and press them inward to seat the SIB.
5.
Tighten the captive screws on the ejector handles.
6.
Repeat the procedure for each of the remaining SIBs.
7.
Chapter 19: Installing the Router into a Rack Without a Mechanical Lift
168):
167