Set Spantree Spanguardtimeout - Enterasys Matrix 2G4072-52 Configuration Manual

6.2.1.58

set spantree spanguardtimeout

Use this command to set the amount of time (in seconds) an edge port will remain locked by the
span guard function.
set spantree spanguardtimeout timeout
Syntax Description
timeout
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the span guard timeout to 600 seconds:
Matrix(rw)->set spantree spanguardtimeout 600
Specifies a timeout value in seconds. Valid values are 0
(forever) to 65535.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Spanning Tree Configuration Command Set
Configuring Spanning Tree Bridge Parameters
6-71