Enterasys Matrix 2G4072-52 Configuration Manual page 966

IP Configuration Command Set
Configuring Routing Interface Settings
12.2.1.2 interface
Use this command to configure interfaces for IP routing. This command enables interface
configuration mode from global configuration mode, and, if the interface has not previously been
created, this command creates a new routing interface. For details on configuration modes
supported by the Matrix Series device and their uses, refer to
interface {vlan vlan-id | loopback loopback-id}
NOTES: VLANs must be created from the switch CLI before they can be configured for
IP routing. For details on creating VLANs and configuring them for IP, refer to
Section 2.3.2.
Each VLAN or loopback interface must be configured for routing separately using the
interface command. To end configuration on one interface before configuring another,
type exit at the command prompt. Enabling interface configuration mode is required for
completing interface-specific configuration tasks. For an example of how these
commands are used, refer to
Each Matrix Series routing module or standalone device can support up to 256 routing
interfaces. Each interface can be configured for the RIP and/or OSPF routing protocols.
Syntax Description
vlan vlan-id |
loopback
loopback-id
Command Type
Router command.
Command Mode
Global configuration mode: Matrix>Router1(config)#
Command Defaults
None.
Example
This example shows how to enter configuration mode for VLAN 1:
Matrix>Router1#configure terminal
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#
12-6 Matrix DFE-Platinum and Diamond Series Configuration Guide
Figure 2-8 in Section 2.3.1.
Specifies the number of the VLAN or loopback interface to
be configured for routing. This interface must be configured
for IP routing as described in
Table 2-11 in Section
Section 2.3.1.
2.3.3.