Show Logging Application - Enterasys Matrix 2G4072-52 Configuration Manual

11.2.1.8

show logging application

Use this command to display the severity level of Syslog messages for one or all applications
configured for logging on your system.
show logging application [mnemonic | all]
Syntax Description
mnemonic | all
NOTE:
Mnemonic values are case sensitive and must be typed as they appear in
Table 11-3.
Command Defaults
If not specified, information for all applications will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Logging And Network Management Command Set
(Optional) Displays severity level for one or all
applications configured for logging. Mnemonics will vary
depending on the number and types of applications
running on your system. To display a complete list, use the
show logging application command as described in
Section 11.2.1.8. Sample values and their corresponding
applications are listed in
Matrix DFE-Platinum and Diamond Series Configuration Guide
Configuring System Logging
Table 11-3.
11-13