Set Rmon Event Status - Enterasys Matrix 2G4072-52 Configuration Manual

11.2.4.13 set rmon event status

Use this command to enable an RMON event entry. An event entry describes the parameters of an
RMON event that can be triggered. Events can be fired by RMON alarms and can be configured to
create a log entry, generate a trap, or both.
set rmon event status index enable
NOTE:
An RMON event entry can be created using this command, configured using
set rmon event properties
the
this command. An RMON event entry can be created and configured at the same time
by specifying an unused index with the set properties command.
Syntax Description
index
enable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to enable RMON event entry 1:
Matrix(rw)->
command
Specifies an index number for this entry. Maximum
number of entries is 100. Maximum value is 65535.
Enables this event entry.
set rmon event status 1 enable
Matrix DFE-Platinum and Diamond Series Configuration Guide
Logging And Network Management Command Set
(Section 11.2.4.12), then enabled using
Configuring RMON
11-67