Set Linkflap Threshold - Enterasys Matrix 2G4072-52 Configuration Manual

4.3.8.9

set linkflap threshold

Use this command to set the link flap action trigger count.
set linkflap threshold port-string threshold_value
Syntax Description
port-string
threshold_value
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the link flap threshold on port fe.1.4 to 5:
Matrix(rw)->set linkflap threshold fe.1.4 5
Specifies the port(s) on which to set the link flap action
trigger count. For a detailed description of possible
port-string values, refer to
Specifies the number of link down transitions necessary to
trigger the link flap action.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Section 4.1.1.
4-79