Show Spantree Spanguardtimeout; Set Spantree Spanguardtimeout - Enterasys SecureStack C2 C2G170-24 Configuration Manual

show spantree spanguardtimeout

Use this command to display the Spanning Tree SpanGuard timeout setting.
Syntax
show spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard timeout setting:
C2(su)->show spantree spanguardtimeout
Spanguard timeout: 300

set spantree spanguardtimeout

Use this command to set the amount of time (in seconds) an edge port will remain locked by the
SpanGuard function.
Syntax
set spantree spanguardtimeout timeout
Parameters
timeout
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the SpanGuard timeout to 600 seconds:
C2(su)->set spantree spanguardtimeout 600
Specifies a timeout value in seconds. Valid values are 0 to 65535.
A value of 0 will keep the port locked until manually unlocked. The default
value is 300 seconds.
show spantree spanguardtimeout
SecureStack C2 Configuration Guide 9-27