Enterasys Matrix 2G4072-52 Configuration Manual page 865

Table 11-9 provides an explanation of the command output. Properties are set using
the set rmon topN properties command as described in
Table 11-9 show rmon topN Output Details
Output
Index
Status
Owner
Start Time
HostIndex
Rate Base
Duration
Time Remaining
Requested Size
Granted Size
Rate
Address
Matrix DFE-Platinum and Diamond Series Configuration Guide
Logging And Network Management Command Set
What It Displays...
Index number for this event entry. Each entry defines one
top N report prepared for one interface.
Whether this event entry is enabled (valid) or disabled.
Text string identifying who configured this entry.
System up time when this report was last started.
Index number of the host table for which this top N report
will be prepared.
Type of counter (and corresponding integer value) activated
with this entry: as InPackets (1), OutPackets (2), InOctets (3),
OutOctets (4), OutErrors (5), Broadcast packets (6), or
Multicast packets (7).
Collection time (in seconds) for this report.
Collection time left for this report if still in progress.
Maximum number of hosts requested for the top N table.
Actual maximum number of hosts in the top N table.
Depending on system resources, this may differ from the
Requested Size value.
Amount of change in the counter type (InPackets,
OutPackets, etc.) during the sampling interval.
MAC address of the host.
Configuring RMON
Section 11.2.4.20.
11-75