5.3.7.5
set snmp notifyfilter
Use this command to create an SNMP notify filter configuration. This identifies which management
targets should NOT receive notification messages, which is useful for fine-tuning the amount of
SNMP traffic generated.
set snmp notifyfilter profile subtree oid-or-mibobject [mask mask] [included |
excluded] [volatile | nonvolatile]
Syntax Description
profile
subtree
oid-or-mibobject
mask mask
included | excluded (Optional) Specifies that subtree is included or excluded.
volatile |
nonvolatile
Command Defaults
•
•
•
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create an SNMP notify filter called "pilot1" with a MIB subtree ID of
1.3.6:
Matrix(rw)->set snmp notifyfilter pilot1 subtree 1.3.6
Specifies an SNMP filter notify name.
Specifies a MIB subtree ID target for the filter.
(Optional) Applies a subtree mask.
(Optional) Specifies a storage type.
If not specified, mask is not set.
If not specified, subtree will be included.
If storage type is not specified, nonvolatile (permanent) will be applied.
Matrix DFE-Platinum and Diamond Series Configuration Guide
SNMP Configuration Command Set
Configuring SNMP Notification Parameters
5-59