Set Lacp Asyspri - Enterasys Matrix 2G4072-52 Configuration Manual

Configuring LACP
Configuring Link Aggregation
4.5.4.4

set lacp asyspri

Use this command to set the LACP system priority. LACP uses this value to determine aggregation
precedence. If there are two partner devices competing for the same aggregator, LACP compares
the LAG IDs for each grouping of ports. The LAG with the lower LAG ID is given precedence and
will be allowed to use the aggregator.
NOTE: Only one LACP system priority can be set on a Matrix Series device, using
either this command, or the set port lacp command
set lacp asyspri value
Syntax Description
asyspri
value
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set the LACP system priority to 1000:
Matrix(rw)->set lacp asyspri 1000
4-104 Matrix DFE-Platinum and Diamond Series Configuration Guide
Sets the system priority to be used in creating a LAG
(Link Aggregation Group) ID. Valid values are 0 to
65535.
Specifies a system priority value. Valid values are 0 to
65535, with precedence given to lower values.
(Section 4.5.4.13).