IP Configuration Command Set
Reviewing and Configuring the ARP Table
12.2.4.1
show ip arp
Use this command to display entries in the ARP (Address Resolution Protocol) table. ARP converts
an IP address into a physical address.
show ip arp [ip-address] [vlan vlan-id] [output-modifier]
Syntax Description
ip-address
vlan vlan-id
output-modifier
Configuration Mode
Any router mode.
Command Defaults
If no parameters are specified, all entries in the ARP cache will be displayed.
12-20 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Displays ARP entries related to a specific IP
address.
(Optional) Displays only ARP entries learned through a
specific VLAN interface. This VLAN must be configured
for IP routing as described in
(Optional) Displays ARP entries within a specific range.
Options are:
•
| begin ip-address — Displays only ARP entries that
begin with the specified IP address.
•
| exclude ip-address — Excludes ARP entries
matching the specified IP address.
•
| include ip-address — Includes ARP entries
matching the specified IP address.
Section
2.3.1.