Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
4.3.8.6
set linkflap interval
Use this command to set the time interval (in seconds) for accumulating link down transitions.
set linkflap interval port-string interval_value
Syntax Description
port-string
interval_value
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Examples
This example shows how to set the link flap interval on port fe.1.4 to 1000 seconds:
Matrix(rw)->set linkflap interval fe.1.4 1000
4-76 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the port(s) on which to set the link flap interval.
For a detailed description of possible port-string values,
refer to
Section
4.1.1.
Specifies an interval in seconds. A value of 0 will set the
interval to forever.