Set Cos Port-Resource Txq - Enterasys Matrix 2G4072-52 Configuration Manual

Policy Classification Configuration Command Set
Configuring Policy Class of Service (CoS)
8.3.3.13

set cos port-resource txq

Use this command to configure a Class of Service transmit queue port resource entry.
set cos port-resource txq group-type-index transmit-queue {[unit {percentage |
kbps | mbps | gbps}] [rate rate] [algorithm {tail-drop}]}
Syntax Description
group-type-index
transmit-queue
unit percentage |
kbps | mbps | gbps
rate rate
algorithm tail-drop (Optional) Sets the algorithm by which transmit frames
Command Defaults
•
•
Command Type
Switch command.
Command Mode
Read-Write.
8-78 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a transmit queue port group/type index for this
entry. Valid entries are in the form of group.type. Group
can be 0-7, with 0 designating the default group, and 1-7
reserved for user-defined groups. Default port type values
cannot be changed, and are 0 for the Matrix
DFE-Platinum 7G4270-12 module, and 1 for all other
modules.
Specifies a transmit queue to be associated with this
entry. Valid values are 0-7.
Specifies the unit of measure as percentage of total
bandwidth, or kilobits, megabits, or gigabits per second.
(Optional) Specifies a data rate in units for this transmit
queue.
are discarded as discarding frames from the tail of the
queue.
If a rate is not specified, port defaults will be applied.
If not specified, no algorithm will be assigned.