Set Summertime Date - Enterasys Matrix 2G4072-52 Configuration Manual

2.2.3.16

set summertime date

Use this command to configure specific dates to start and stop daylight savings time. These settings
will be non-recurring and will have to be reset annually.
set summertime date start_month start_date start_year start_hr_min end_month
end_date end_year end_hr_min [offset_minutes]
Syntax Description
start_month
start_date
start_year
start_hr_min
end_month
end_date
end_year
end_hr_min
offset_minutes
Command Defaults
If an offset is not specified, none will be applied.
Command Type
Switch command.
Command Mode
Read-Write.
Specifies the month of the year to start daylight savings
time.
Specifies the day of the month to start daylight savings
time.
Specifies the year to start daylight savings time.
Specifies the time of day to start daylight savings time.
Format is hh:mm.
Specifies the month of the year to end daylight savings
time.
Specifies the day of the month to end daylight savings
time.
Specifies the year to end daylight savings time.
Specifies the time of day to end daylight savings time.
Format is hh:mm.
(Optional) Specifies the amount of time in minutes to
offset daylight savings time from the non-daylight
savings time system setting. Valid values are 1 - 1440.
Matrix DFE-Platinum and Diamond Series Configuration Guide
General Configuration Command Set
Setting Basic Device Properties
2-63