Matrix Series CLI Overview
1.2
MATRIX SERIES CLI OVERVIEW
Enterasys Networks' Matrix Series CLI interface allows you to perform a variety of network
management tasks, including the following:
•
Assign IP address and subnet mask.
•
Select a default gateway.
•
Assign a login password to the device for additional security.
•
Download a new firmware image.
•
Designate which network management workstations receive SNMP traps from the device.
•
View device, interface, and RMON statistics.
•
Manage configuration files.
•
Assign ports to operate in the standard or full duplex mode.
•
Control the number of received broadcasts that are switched to the other interfaces.
•
Set flow control on a port-by-port basis.
•
Set port configurations and port-based VLANs.
•
Configure ports to prioritize and assign a VLAN or Class of Service to incoming frames based
on Layer 2, Layer 3, and Layer 4 information.
•
Configure the device to operate as a Generic Attribute Registration Protocol (GARP) device to
dynamically create VLANs across a switched network.
•
Redirect frames according to a port or VLAN and transmit them on a preselected destination
port.
•
Configure Spanning Trees.
•
Clear NVRAM.
•
Configure interfaces for IP routing.
•
Configure RIP, OSPF, DVMRP, IRDP and VRRP routing protocols.
•
Configure security methods, including 802.1X. RADIUS,
locking, and DoS attack prevention.
•
Configure access lists (ACLs).
1-2 Matrix DFE-Platinum and Diamond Series Configuration Guide
TACACS
, CEP, SSHv2, MAC