Enterasys Matrix 2G4072-52 Configuration Manual page 986

IP Configuration Command Set
Reviewing and Configuring the ARP Table
12.2.4.6 ip mac-address
Use this command to set a MAC address on an interface.
ip mac-address address
NOTE: By default, every routing interface uses the same MAC address. If the user
needs interfaces to use different MAC addresses, this command will allow it. It is the
user's responsibility to select a MAC address that will not conflict with other devices on
the VLAN since the Matrix Series device will not automatically detect this conflict.
Syntax Description
address
Command Syntax of the "no" Form
The "no" form of this command clears the MAC address:
no ip mac-address
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set an IP MAC address of 000A.000A.000B. on VLAN 1:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip mac-address 000A.000A.000B
12-26 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a 48-bit MAC address in hexadecimal format.