Enterasys Matrix 2G4072-52 Configuration Manual page 212

Discovery Protocols Command Set
Cisco Discovery Protocol
Table 3-3 show port ciscodp info Output Details
Output
Port
State
VVID
Trust
CoS
3-16 Matrix DFE-Platinum and Diamond Series Configuration Guide
What It Displays...
Port designation.
Whether CiscoDP is enabled or disabled on this port.
Default state of enabled can be changed using the set
ciscodp port command
Whether a Voice VLAN ID has been set on this port. Default
of none can changed using the set ciscodp port command
(Section 3.2.3.6).
The trust mode of the port. Default of trusted can be changed
using the set ciscodp port command
The Class of Service priority value for untrusted traffic. The
default of 0 can be changed using the set ciscodp port
command (Section 3.2.3.6).
(Section 3.2.3.6).
(Section 3.2.3.6).