11.2.8.4
set netflow export-destination
Use this command to configure the NetFlow collector destination. By default, no collector address
is configured. Only one collector destination per Matrix system can be configured.
set netflow export-destination ip-address [udp-port]
Syntax Description
ip-address
udp-port
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write
Example
This example shows how to set the IP address of the NetFlow collector
Matrix(rw)->set netflow export-destination 10.10.1.1
Specifies the IP address of the NetFlow collector.
(Optional) Specifies the UDP port number used by the
NetFlow collector. Default is 2055.
Matrix DFE-Platinum and Diamond Series Configuration Guide
Logging And Network Management Command Set
:
Configuring NetFlow
11-159