IP Configuration Command Set
Performing a Basic Router Configuration
12.2.3.3
Configuring the Router
You can configure the router using either of the following methods.
Using a downloaded file...
1. Download a router config file to the standalone or chassis using the copy command as described
in
Section
2.2.9.5.
2. Run the configure command using the downloaded config file as described in
Creating and saving a custom file...
1. Configure a module for routing using the set router command as described in
2. Enable the router as described in
Figure 12-1
for an example of a basic config file.)
3. Save the configuration using the write file command as described in
12.2.3.4
Moving a Config File from Another Routing Module
To copy a router configuration from one module to another, proceed as follows:
1. From the routing module in which you wish to copy a config file, perform a show config on the
file as described in
2. Copy the config file to a place where it can be edited with a file editing program.
3. If you only want the router config, delete all the non-routing config elements and save the new
file.
4. Change the routing instance to the module to which the config will be moved as described in
Section
2.3.3.
5. Use the copy command to move the config file to the new module as described in
Section
2.2.9.5.
6. Run the configure command using the new config file as described in
12-18 Matrix DFE-Platinum and Diamond Series Configuration Guide
Section 2.3.3
Section
2.2.9.3.
and configure it manually. (Refer back to
Section
2.2.9.4.
Section
2.3.2.2.
Section
12.2.2.2.
Section
2.2.9.4.