Enterasys Matrix 2G4072-52 Configuration Manual page 1003

distributed to every module for use by the router's distributed forwarding engine on
the ingress module as frames are received.
Command Defaults
If no parameters are specified, all IP route information will be displayed.
Example
This example shows how to display all IP route information. In this case, there are routes directly
connected to VLANs 1 and 2, two static routes connected to VLAN 1 (one indirectly, and one via
another network IP), and one RIP route. Distance/cost is displayed as [x/y]:
Matrix>Router1#show ip route
Codes: C – connected, S –
– OSPF NSSA external type 1, N2 – OSPF NSSA external type 2, E1 – OSPF external
type 1, E2 – OSPF external type 2, * - candidate default, U – per user static
route
C 192.168.27.0/24
C 192.168.32.0/24
S 2.0.0.0/8
S 3.0.0.0/8
R 1.0.0.0/8
static, R – RIP, O – OSPF, IA – OSPF inter area, N1
[ 0/0001] directly connected, vlan 1
[ 0/0001] directly connected, vlan 2
[ 65/0001] via 192.168.72.1, vlan 1
[ 0/0001] directly connected vlan 1
[ 70/0002] via 192.168.72.22 vlan 1
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12-43