12.2.7.5
ip pim rp-candidate
Use this command to enable the router to advertise itself as a PIM candidate rendezvous point (RP)
to the BSR. Only one RP candidate can be configured per routing module or standalone device.
ip pim rp-candidate pim-interface group-address group-mask [priority priority]
Syntax Description
pim-interface
group-address
group-mask
priority priority
Command Syntax of the "no" Form
The no form of this command removes the router as an RP candidate:
no ip pim rp-candidate pim-interface group-address group-mask
Command Type
Router command.
Command Mode
Global configuration: Matrix>Router1(config)#
Command Defaults
If not specified, a DR priority value of 192 will be assigned.
Example
This example enables the PIM interface at 35.0.0 224.0.0 240.0.0 to advertise itself as an RP
candidate with a priority of 124:
Matrix>Router1(config)#ip pim rp-candidate 35.0.0.1 224.0.0.0 240.0.0.0
priority 124
Interface to advertise as an RP candidate. This interface
must be enabled with PIM as described in
Specifies the multicast group address.
Specifies the multicast group mask.
(Optional) Specifies an RP priority value, ranging from 0 -
255. Lower values assign higher priority.
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
Configuring PIM
Section
12.2.7.1.
12-55