Configuring Port Mirroring
Setting Port Mirroring
4.4.4.2
set port mirroring
Use this command to create a new mirroring relationship or to enable or disable an existing
mirroring relationship between two ports.
set port mirroring {create | disable | enable} | igmp-mcast {enable |
disable}source destination [both | rx | tx]
Syntax Description
create | disable |
enable
igmp-mcast enable
| disable
source
destination
both | rx | tx
Command Defaults
If not specified, both received and transmitted frames will be mirrored.
Command Type
Switch command.
Command Mode
Read-Write.
4-92 Matrix DFE-Platinum and Diamond Series Configuration Guide
Creates, disables or enables mirroring settings on the
specified ports.
Enables or disables the mirroring of IGMP multicast
frames.
Specifies the source port designation. This is the port on
which the traffic will be monitored. For a description of
port types that can participate in mirroring, refer to
Section
4.4.1. For a detailed description of possible
port-string values, refer to
Specifies the target port designation. This is the port that
will duplicate or "mirror" all the traffic on the monitored
port. For a description of possible destination port
configurations supported on the Matrix Series device,
refer to
Section
4.4.3. For a detailed description of
possible port-string values, refer to
(Optional) Specifies that frames received and transmitted
by the source port, only frames received, or only frames
transmitted will be mirrored.
Section
4.1.1.
Section
4.1.1.