Enterasys Matrix 2G4072-52 Configuration Manual page 332

Port Configuration Command Set
Configuring Link Traps and Link Flap Detection
Table 4-5
output.
Table 4-5 show linkflap parameters Output Details
Output
Port
LF Status
Actions
Threshold
Interval
Downtime
This example shows how to display the link flap metrics table:
Matrix(rw)->show linkflap metrics
Port LinkStatus
-------- -----------
ge.1.1 operational
ge.1.2 disabled
ge.1.3 operational
Table 4-6
Table 4-6 show linkflap metrics Output Details
Output
Port
LinkStatus
CurrentCount
TotalCount
4-72 Matrix DFE-Platinum and Diamond Series Configuration Guide
provides an explanation of the show linkflap parameters command
What It Displays...
Port designation. For a detailed description of possible
port-string values, refer to
Link flap enabled state.
Actions to be taken if the port violates allowed link flap
behavior. D = disabled, S = Syslog entry will be generated,
T= SNMP trap will be generated.
Number of link down transitions necessary to trigger the link
flap action.
Time interval (in seconds) for accumulating link down
transitions.
Interval (in seconds) port(s) will be held down after a link
flap violation
CurrentCount
------------
0
4
3
provides an explanation of the show linkflap metrics command output.
What It Displays...
Port designation. For a detailed description of possible
port-string values, refer to
Link status according to the link flap function.
Link down count accruing toward the link flap threshold.
Number of link downs since system start,
Section
TotalCount TimeElapsed
---------- ----------- -------------
0 241437
15 147
3 241402
Section
4.1.1.
Violations
0
5
0
4.1.1.