Port Configuration Command Set
Setting Speed and Duplex Mode
4.3.4.2
set port speed
Use this command to set the default speed of one or more ports. This setting only takes effect on
ports that have auto-negotiation disabled.
set port speed port-string {10 | 100 | 1000}
Syntax Description
port-string
10 | 100 | 1000
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set Fast Ethernet port 3 in module3 to a port speed of 10 Mbps:
Matrix(rw)->set port speed fe.3.3 10
4-44 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the port(s) for which to a speed value will be
set. For a detailed description of possible port-string
values, refer to
Section
Specifies the port speed. Valid values are: 10 Mbps,
100 Mbps, or 1000 Mbps.
4.1.1.