Enterasys Matrix 2G4072-52 Configuration Manual page 971

12.2.1.6 no shutdown
Use this command to enable an interface for IP routing and to allow the interface to automatically
be enabled at device startup.
no shutdown
Syntax Description
None.
NOTE: The shutdown form of this command disables an interface for IP routing.
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to enable VLAN 1 for IP routing:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#no shutdown
Matrix DFE-Platinum and Diamond Series Configuration Guide
IP Configuration Command Set
Configuring Routing Interface Settings
12-11