Set Lacp - Enterasys Matrix 2G4072-52 Configuration Manual

Configuring LACP
Configuring Link Aggregation
4.5.4.2

set lacp

Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device. LACP is enabled by default.
set lacp {disable | enable}
Syntax Description
disable | enable
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to disable LACP:
Matrix(rw)->set lacp disable
4-102 Matrix DFE-Platinum and Diamond Series Configuration Guide
Disables or enables LACP.