Set Vlan Interface - Enterasys Matrix 2G4072-52 Configuration Manual

VLAN Configuration Command Set
Assigning Port VLAN IDs (PVIDs) and Ingress Filtering
7.3.3.5

set vlan interface

Use this command to create, disable or enables a MIB-II interface mapped to a VLAN.
set vlan interface vlan-list {create | disable | enable} [volatile]
Syntax Description
vlan-list
create | disable |
enable
volatile
Command Defaults
If volatile is not specified, entries will be created as nonvolatile.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to create a volatile interface entry mapped to VLAN 1:
Matrix(rw)->set vlan interface 1 volatile
7-18 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the VLAN(s) for which an interface entry will
be created, disabled or enabled.
Creates, disables or enables an interface entry.
(Optional) When the create keyword is used, stores the
entry as a volatile entry. Volatile entries are lost when a
system is reset. Non-volatile entries are saved in
NVRAM and are persistent until cleared.