Configuring Discovery Protocols; Overview; Discovery Protocols Command Set; Displaying Neighbors - Enterasys Matrix 2G4072-52 Configuration Manual

This chapter describes how to configure the discovery protocols supported by the firmware using
CLI commands.
3.1

OVERVIEW

Currently, three discovery protcols are supported:
•
The Enterasys Discovery (CDP), described in
page 3-4
•
The Cisco Discovery Protocol, described in
3-12
•
The IEEE 802.1AB Link Layer Discovery Protocol (LLDP) and LLDP Media Endpoint
Discovery Protcol (LLDP-MED), described in
and LLDP-MED," on
3.2

DISCOVERY PROTOCOLS COMMAND SET

3.2.1

Displaying Neighbors

Purpose
The show neighbors command displays neighbor discovered by all support discovery protocols.
Command
•
show neighbors (Section

Configuring Discovery Protocols

page 3-25
3.2.1.1)
Matrix DFE-Platinum and Diamond Series Configuration Guide
Section 3.2.2, "Enterasys Discovery
Section 3.2.3, "Cisco Discovery
Section 3.2.4, "Link Layer Discovery Protocol
3
Protocol," on
Protocol," on page
3-1