Enterasys Matrix 2G4072-52 Configuration Manual page 747

9.3.2.1 show port priority-queue
Use this command to display the port priority levels (0 through 7, with 0 as the lowest level)
associated with the current transmit queue (0 - 15 depending on port type, with 0 being the lowest
priority) for each priority of the selected port. A frame with a certain port priority is transmitted
according to the settings entered using the set priority queue command described in
Section 9.3.2.2.
show port priority-queue [priority]
Syntax Description
priority
Command Defaults
If priority is not specified, all priority queue information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Examples
This example shows how to display priority queue information for fe.1.7. In this case, the frames
shown with a priority of 0 or 3 are transmitted according to the transmit priority queue of 1 (the
second lowest transmit priority); frames with 1 or 2 priority, at the lowest transmit priority of 0;
frames with 4 or 5 priority, at the second highest transmit priority of 2; and frames with 6 or 7
priority, at the highest transmit priority of 3:
Matrix(rw)->show port priority-queue fe.1.7
fe.1.7
----------
Port Priority and Rate Limiting Configuration Command Set
(Optional) Displays queue levels for a specific priority
value.
Priority TxQueue
-------- -------
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
Matrix DFE-Platinum and Diamond Series Configuration Guide
Configuring Priority to Transmit Queue Mapping
9-7