Enterasys Matrix 2G4072-52 Configuration Manual page 178

General Configuration Command Set
Resetting the Device
2.2.12.2 reset
Use this command to reset the device without losing any user-defined configuration settings
reset {[mod | system | nemcpu {mod.nemcpu}] [cancel]}
NOTE: A Matrix Series device can also be reset with the RESET button located on its
front panel. For information on how to do this, refer to the Matrix Installation Guide
shipped with your device.
Syntax Description
mod
system
nemcpu
mod.nemcpu
cancel
Command Defaults
None.
Command Mode
Read-Write.
Examples
This example shows how to reset the system.
Matrix(rw)->reset
This command will reset the system and may disconnect your telnet session.
Do you want to continue (y/n) [n
Resetting...
2-152 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies a module to be reset.
Resets the system.
Resets the CPU on a Matrix Security Module or other
processing NEM, where mod specifies the DFE module in
which the Matrix Security Module or processing NEM is
installed and nemcpu specifies the location of the NEM.
Currently, this value can only be 1.
Cancels a reset scheduled using the reset at command as
described in Section
described in Section
]
? y
2.2.12.3, or the reset in command as
2.2.12.4.