Set Lldp Port Tx-Tlv - Enterasys Matrix 2G4072-52 Configuration Manual

Discovery Protocols Command Set
Link Layer Discovery Protocol and LLDP-MED
3.2.4.17

set lldp port tx-tlv

Use this command to select the optional LLDP and LLDP-MED TLVs to be transmitted in
LLDPDUs by the specified port or ports. Use the
values of these TLVs for the port.
set lldp port tx-tlv {[all] | [port-desc] [sys-name] [sys-desc] [sys-cap]
[mgmt-addr] [vlan-id] [stp] [lacp] [gvrp] [mac-phy] [poe] [link-aggr]
[max-frame] [med-cap] [med-pol] [med-loc] [med-poe]} port-string
Syntax Description
all
port-desc
sys-name
sys-desc
sys-cap
mgmt-addr
vlan-id
stp
lacp
gvrp
3-50 Matrix DFE-Platinum and Diamond Series Configuration Guide
show lldp port local-info
Add all optional TLVs to transmitted LLDPDUs.
Port Description optional basic LLDP TLV. Value sent is
ifDescr object defined in RFC 2863.
System Name optional basic LLDP TLV. Value sent is the
administratively assigned name for the system.
System Description optional basic LLDP TLV. Value sent
is sysDescr object defined in RFC 3418.
System Capabilities optional basic LLDP TLV. For a
network connectivity device, value sent can be bridge
and/or router.
Management Address optional basic LLDP TLV. Value
sent is IPv4 address of host interface.
Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is
port VLAN ID (PVID).
Spanning Tree information defined by Protocol Identity
IEEE 802.1 Extensions TLV. If STP is enabled on the
port, value sent includes version of protocol being used.
LACP information defined by Protocol Identity IEEE
802.1 Extensions TLV. If LACP is enabled on the port,
value sent includes version of protocol being used.
GVRP information defined by Protocol Identity IEEE
802.1 Extensions TLV. If LACP is enabled on the port,
value sent includes version of protocol being used.
command to display the