SNMP Configuration Command Set
Configuring SNMP Notification Parameters
5.3.7.4
show snmp notifyfilter
Use this command to display SNMP notify filter information, identifying which profiles will not
receive SNMP notifications.
show snmp notifyfilter [profile] [subtree oid-or-mibobject] [volatile |
nonvolatile | read-only]
Syntax Description
profile
subtree
oid-or-mibobject
volatile |
nonvolatile |
read-only
Command Defaults
If no parameters are specified, all notify filter information will be displayed.
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SNMP notify filter information. In this case, the notify profile
"pilot1" in subtree 1.3.6 will not receive SNMP notification messages:
Matrix(rw)->show snmp notifyfilter
--- SNMP notifyFilter information ---
Profile
Subtree
Filter type
Storage type
Row status
5-58 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Displays a specific notify filter.
(Optional) Displays a notify filter within a specific
subtree.
(Optional) Displays notify filter entries of a specific
storage type.
= pilot1
= 1.3.6
= included
= nonVolatile
= active