Enterasys Matrix 2G4072-52 Configuration Manual page 798

Logging And Network Management Command Set
Configuring System Logging
Command Defaults
•
•
•
Command Type
Switch command.
Command Mode
Read-Write.
Example
This command shows how to enable a Syslog server configuration for index 1, IP address
134.141.89.113, facility local4, severity level 3 on port 514:
set logging server 1 ip-addr 134.141.89.113 facility
Matrix(rw)->
local4 severity 3 port 514 state enable
11-8 Matrix DFE-Platinum and Diamond Series Configuration Guide
If ip-addr is not specified, an entry in the Syslog server table will be created
with the specified index number and a message will display indicating that no
IP address has been assigned.
If not specified, facility, severity and port will be set to defaults configured
with the set logging default command
If state is not specified, the server will not be enabled or disabled.
(Section 11.2.1.6.).