Show Port Flowcontrol - Enterasys Matrix 2G4072-52 Configuration Manual

Port Configuration Command Set
Setting Flow Control
4.3.7.1

show port flowcontrol

Use this command to display the flow control state for one or more ports.
show port flowcontrol [port-string]
Syntax Description
port-string
Command Defaults
If port-string is not specified, flow control information for all ports will be
displayed.
Command Mode
Read-Only.
Example
This example shows how to display the port flow control state for fe.1.1-5:
Matrix(rw)->show port flowcontrol fe.1.1-5
Port TX Admin
------------ -------- -------- -------- -------- -------------- --------------
fe.1.1 enabled disabled
fe.1.2 enabled disabled
fe.1.3 enabled
fe.1.4 enabled disabled
fe.1.5 enabled disabled
Table 4-4
Table 4-4 show port flow control Output Details
Output
Port
TX Admin
4-64 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Displays flow control state for specific port(s).
For a detailed description of possible port-string values,
refer to
TX Oper RX Admin
enabled disabled
enabled disabled
enabled enabled
enabled disabled
enabled disabled
provides an explanation of the command output.
What It Displays...
Port designation. For a detailed description of possible
port-string values, refer to
Whether or not the port is administratively enabled or
disabled for sending flow control frames.
Section 4.1.1.
RX Oper TX Pause Count RX Pause Count
enabled
Section
0
0
0
0
0
4.1.1.
0
0
0
0
0