Logging And Network Management Command Set
Configuring SMON
11.2.3.1
show smon priority
Use this command to display SMON user priority statistics. SMON generates aggregated statistics
for IEEE 802.1Q VLAN environments.
show smon priority [port-string] [priority priority]
Syntax Description
port-string
priority priority
Command Defaults
•
•
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display SMON priority 0 statistics for 1-Gigabit Ethernet port 14 in
:
module 3
Matrix(rw)->show smon priority ge.3.14 0
Show Priority Statistics
------------------------
Interface = ge.3.14
Owner
Creation
Status
--------------------
Priority 0 Packets
----------
Total
Overflow
11-38 Matrix DFE-Platinum and Diamond Series Configuration Guide
(Optional) Displays SMON priority statistics being
collected by specific port(s). For a detailed description of
possible port-string values, refer to
(Optional) Displays SMON statistics based on encoded user
priority, Valid values are 0 - 7.
If port-string is not specified, SMON statistics for all ports will be displayed.
If priority is not specified, statistics for all priority queues will be displayed.
= none
= 0 days 0 hours 6 minutes 39 seconds
= enabled
7981308
0
Section
Octets
2332402460
0
4.1.1.