Enterasys Matrix 2G4072-52 Configuration Manual page 996

IP Configuration Command Set
Reviewing IP Traffic and Configuring Routes
12.2.6.2 set router limits route-table
Use this command to set the chassis-based route table limits.
set router limits route-table route-table
NOTE: This command must be executed from the switch CLI.
Syntax Description
route-table
Command Type
Switch command.
Command Mode
Read-Write.
Command Defaults
None.
Example
This example shows how to set the route table limit to 17000:
Matrix(rw)->set router limits route-table 17000
12-36 Matrix DFE-Platinum and Diamond Series Configuration Guide
Sets the route table limit. Valid values are 1 - 25000.
This parameter will also set the maximum allowable OSPF
LSA Type 3 route limit to 8000, and the Type 5 limit to
10,000. For more information on configuring OSPF, refer to
Section 13.2.3.
NOTE: Values above the default size of 12000 routes
require 256 Mb of memory throughout the entire chassis,
and such values will be rejected if this memory upgrade is
not installed.