Configuration Of A Command To The Device - Leica GPS1200+ Technical Reference Manual

Geodetic satellite receiver
Hide thumbs Also See for GPS1200+:
Table of Contents

Advertisement

22.4.4
Configuration of
command step-by-step
Config...\Interfaces... - General

Configuration of a Command to the Device

Step
Description
1.
Refer to "22.4.1 Overview" to access CONFIGURE ASCII Input.
2.
SHIFT CMND (F5)
3.
CONFIGURE Send Command to Device
<Command:> A message to be sent to the device through the configured port
when the survey or stakeout application program is accessed. This, for example,
allows the device to be started remotely. The last used command that was entered
is remembered as part of the active configuration set.
Type in the command to be sent.
4.
SEND (F3) sends the command to the device.
5.
CONT (F1) returns to CONFIGURE ASCII Input.
GPS1200+
521

Advertisement

Table of Contents
loading

Table of Contents