Table of Contents
Advertisement
Equipment setup step-
by-step
Next step
Equipment Setup
c) GNSS antenna AX1201/AX1203+ GNSS
d) Height hook
e) Carrier
f) Tribrach
g) 1.2 m antenna cable to connect receiver and
GNSS antenna
h) Tripod
Step
Description
1.
Refer to "1.3 Post-Processed Static Reference on Tripod". Follow steps 1. to 13.
2.
Clip the antenna arm to the GNSS antenna.
3.
Screw the radio antenna onto the antenna arm.
4.
Attach the radio in its housing to port P1 or P3 on the receiver.
5.
Connect the radio antenna to the radio using the second 1.2 m antenna cable.
6.
Press the ON/OFF button on the receiver for at least 2 s or PROG on the RX1210
to switch the receiver on.
IF the receiver
has been pre-programmed
has been pre-programmed
requires programming
k) Radio in housing
l) Transport container
m) 1.2 m antenna cable to connect radio housing
to radio antenna
n) Two batteries
CompactFlash card
o)
AND the RX1200 is
not being used
being used
being used
GPS1200+
Refer to chapter
3
45
14
54
Advertisement
Table of Contents
