Table of Contents
Advertisement
Cables
Ports to connect equip-
ment
Equipment Setup
a) Port OSC: External oscillator, in
b) Port E1: Event input
c) Battery compartment
with CompactFlash card compartment
d) LED indicators
e) Port P3: Power out, data in/out,
interface in/out
. 8 pin LEMO
f) Port PWR: Power in. 5 pin LEMO
Refer to "Appendix E Cables" for information on cables.
Equipment
RX1210 without cable
RX1210 using a cable
GNSS antenna
Radio in a housing, without cable
Radio without housing, using a cable
Radio in a housing of System 500, using a
cable
External power
g) Port ANT: GNSS antenna in
h) Port NET: Ethernet/LAN data in/out, or remote
interface.
i) Port PPS: PPS output
j) Port RX:
in/out.
or remote
k) Port P2: Power out, data in/out,
interface in/out
l) Port P1: Power out, data in/out,
interface in/out
Port
Direct clip on the receiver
Port RX
Port ANT
Port P1 or port P3
Port P1, port P2 or port P3
Port P1, port P2 or port P3
Port PWR
GPS1200+
RX1200 in/out or remote interface
8 pin LEMO
or remote
. 8 pin LEMO
or remote
. 8 pin LEMO
30
Advertisement
Table of Contents
