Leica GPS1200+ Technical Reference Manual page 48

Next step
Equipment Setup
Step Description
14. Press PROG on the RX1210 to switch the receiver on.
IF the receiver
has been pre-programmed
requires programming
When using the upper pole half with stub, ensure that the GNSS antenna and the screw-to-
stub adapter slide down the full length of the stub before tightening the locking ring. An incor-
rectly mounted GNSS antenna will have a direct effect on the results.
AND the RX1200 is
being used
being used
GPS1200+
Refer to chapter
45
14
48