Table of Contents
Advertisement
Equipment setup step-
by-step
Next step
Equipment Setup
e) 1.2 m antenna cable
f) RX1210 if required
g) Receiver
GX1210+/GX1220+/GX1220+ GNSS/
GX1230+/GX1230+ GNSS
h) Tripod
i) Radio antenna
Step
Description
1.
Refer to "1.3 Post-Processed Static Reference on Tripod". Follow steps 1. to 13.
2.
Attach the radio in its housing to port P1 or P3 on the receiver.
3.
Set up the second tripod nearby.
4.
Screw the base for the telescopic rod onto the tripod.
5.
Screw the radio antenna arm onto the telescopic rod.
6.
Screw the radio antenna onto the arm.
7.
Connect the radio antenna to the radio using the 2.8 m antenna cable.
8.
Push the telescopic rod into the base.
9.
Press the ON/OFF button on the receiver for at least 2 s or PROG on the RX1210
to switch the receiver on.
IF the receiver
has been pre-programmed
has been pre-programmed
n) Radio in housing
o) Transport container
p) Tripod
q) Two batteries
r) CompactFlash card
AND the RX1200 is
not being used
being used
GPS1200+
Refer to chapter
3
45
58
Advertisement
Table of Contents
