Table of Contents
Advertisement
Manage...\Data
Step
Description
10.
CONT (F1)
11.
SURVEY Survey: Job Name
Measure P1. This point is automatically added to all three lines open
at that time.
12.
Press F7.
13.
MANAGE Data: Job Name, Lines (X) page
Highlight the line F1.
CLOSE (F4) to close the line.
14.
Highlight the line F2.
CLOSE (F4) to close the line.
Line G1 stays open.
15.
CONT (F1)
16.
SURVEY Survey: Job Name
Measure points along gate G1. These points are automatically added
to line G1.
17.
After finishing the survey, import the data into a CAD package.
If the line codes required by the CAD package were used, the lines
are automatically connected and the point symbols are automatically
set.
GPS1200+
Refer to
chapter
45.3.3
45.3.3
196
Advertisement
Table of Contents
