Table of Contents
Advertisement
Equipment setup step-
by-step
Equipment Setup
c) Height hook
d) Tribrach
e) 2.8 m antenna cable
f) RX1210 if required
Step
Description
1.
Set up the tripod.
2.
Mount and level the tribrach on the tripod.
3.
Ensure that the tribrach is over the marker.
4.
Place and lock the carrier in the tribrach.
5.
Screw the GNSS antenna onto the carrier.
6.
Check that the tribrach is still level.
7.
Insert the batteries into the receiver.
8.
Insert the CompactFlash card into the receiver.
9.
Connect the receiver to the GNSS antenna using the antenna cable and port ANT
on the receiver.
10.
Attach the RX1210 to the receiver if required.
11.
To hang the receiver on the tripod leg, use the hook on the rear of the unit. Or place
the receiver in the transport container.
12.
Insert the height hook into the carrier.
13.
Measure the antenna height using the height hook.
14.
Press the ON/OFF button on the receiver for at least 2 s or PROG on the RX1210
to switch the receiver on.
i) CompactFlash card
j) Tripod
k) Transport container
GPS1200+
37
Advertisement
Table of Contents
